Farmhouse Nightstand Design Ideas

Small Wood Nightstand Design Ideas

Farmhouse nightstand – Bedside tables are easily customized for the height of the bed and the style of your room so they make a great practical project for someone who is new to carpentry. A traditional bedside table design might not be the best option for you if you move frequently, redesign often or have a low bed size. Instead, several small wooden cubes are combined to make a modular bedside table. This way you can create a bedside table is the perfect height and width for your changing night getaways. Cut Board 1 of 12 inches in four pieces 11 1/4 inches long. Remove any excess wood. Cut a sheet of plywood 1 foot long and wide. Use a steel carpenter’s square to make 90-degree corners. Drill a 1-inch hole in the center of each board. Sand joints and cut edges of the wood with sandpaper or sanding block. Clean the joints and the sheet with a sticky rag.

Make best farmhouse nightstand, retention of the boards vertically so that the 3/4 inch side faces the work surface. Line the left corner of the board with the upper left corner of the plywood. Place the bottom board on the tail so that it is aligned with the top edge of the sheet of plywood. There will be a 3/4 inch wide space on the far right side of the sheet of plywood. Place a second plate on the right side of the sheet of plywood by aligning the joint with the upper right corner of the plywood. The two boards will meet to form an “L” and there will be a gap in the lower right corner of the sheet of plywood.

Best Post:   Fantastic Ideas to Install a Floating Nightstand

Then, align a third board with the lower right corner and the lower edge of the plywood. Complete the picture by placing the last board to the left of the sheet of plywood. Place the frame of the bedside table on the edge of the table. Attach the four clamps, one at each corner to hold the vertical boards in place. Use additional clamps if necessary. Wipe off any excess glue with a damp cloth. Allow the glue to fix overnight. Flip the box over. Remove the clamps. Fasten the nails to the rectangle with 2 or 3 inches. Nails on the perimeter of the plywood base 3/8 inch from the edge. Put a nail every 2 inches. Fill all nail holes with wood putty. Dry the piece during the night. Sand the bedside table. Clean the piece with a sticky rag. Apply a layer of varnish by brushing perpendicular to the grain. Allow the varnish to dry overnight. Apply a second coat of varnish once the first coat is completely dry. Varnish decorates and protects the bedside table.